• Power factor correction is the established method of reducing electricity costs in industry and commerce
• You can eliminate waste in electricity consumption by improving your power factor and saving up to 20% on your electricity costs
• This could also help you to increase your output without the need to install new cables or extra supply capacity.

• Self healing properties enable capacitors to continue operating after the occurrence of a short circuit between the plates
• Units are environmentally friendly
• Incorporates patented safety device which disconnects both connections to the element, in case of element breakdown

Low loss - less than 0.5 watts per kvar, including discharge resistors.
Environmentally safe, the dry type construction eliminates flammable impregnants and does not cause leakage or pollution problems.

Standard voltage 415V - capacitors suitable for use on other voltages available on request.

• Meets the requirements of IEC 831, BS 1650, IEC 70/70A
• Self healing properties enable capacitors to continue operating after the occurrence of a short circuit between the plates
• Units are environmentally friendly
• Incorporates patented safety device which disconnects both connections to the element, in case of element breakdown

Designed for the manual or automatic bulk power factor correction of small industrial loads or load centres in one or two switching stages.

Units comprise a Memcap low loss dry-type metallised film capacitor with integrally mounted control equipment.

• Meets the requirements of IEC 831, BS 5486
• Manual or fully automatic control
• Low loss
• Self healing
• Individually fused elements
• Non flammable construction
• Environmentally friendly
• Easy maintenance
• Requires front access only
• Floor or wall mounting

Designed for fully automatic bulk power factor correction of medium size industrial loads.
Units can be supplied in single or multi-stage switching steps, with or without a main integral fuse-switch.

The equipment is of a non flammable, environmentally friendly construction, with easy access for maintenance.

• Meets the requirements of IEC 831, BS 1650, IEC 70/70A
• Self healing properties enable capacitors to continue operating after the occurrence of a short circuit between the plates
• Units are environmentally friendly
• Incorporates patented safety device which disconnects both connections to the element, in case of element breakdown

Designed for the automatic power factor correction of industrial loads.
Units can be supplied with a reactive sensing relay or arranged to operate from existing control devices.

Cubicles can house up to 300kvar of capacitors switched in stages of 25 to 100kvar dependent upon requirements.

• Meets the requirements of IEC 831, BS 1650, IEC 70/70A
• Fully automatic control
• Easily extendible
• Low loss
• Self healing
• Individually fused elements
• Non flammable construction
• Environmentally friendly
• Easy maintenance
• Requires front access only

• Continues to guarantee efficient harmonic compensation even when changes are made to the installation
• Easy to use and install
• Auto configures to harmonic loads whatever their magnitude
• Not susceptible to harmonic overload
• Compatible with electrical generators
• Can be connected to any point in the network
• Additional units can be added to meet future system requirements

Manufactured in a wide range of ratings and enclosures, medium and high voltage capacitors are electrically proven, single and three phase low loss units, suitable for indoor and outdoor installation.

All products comply with international standards and use environmentally friendly PCB-free impregnant.

• Dielectric comprises several layers of polypropylene film impregnated with an insulating fluid
• Designed to withstand high stresses
• Highly efficient back-up protection, with each individual element safeguarded by a built-in, series connected fuse
• Suitable for indoor or outdoor use in cubicles, tanks or open racks
• Wall or floor mounting
• Wide range of accessories available